1. Holding the machine: Hold the machine base with four fingers of your right hand, place your thumb naturally on the cover of the machine, and hold the entire machine smoothly. 2. Threading: Gently pull out the thread on the spool. Pass through the lead coil again. Temporarily place the threaded end next to the needle, and pass the threading device through the needle hole from the front of the needle (towards the junction of the machine body). Then, introduce the threaded end into the small hole of the threading device, exit the threading device, and pull out the threaded end about 2-3 cm. Press the thread pressing plate to use. 3. Cloth placement: Use your right index finger to lift the pressure plate, place the prepared fabric (thickness not exceeding 0 mm) flat under the pressure plate, and gently put it back onto the pressure plate to press the fabric; 4. Sewing operation: Hold the fabric with your left hand, gently and quickly press the top of the upper cover to the bottom with your right thumb, then press down again with your thumb. Repeat this process, and the fabric feeding mechanism will automatically send the sewn fabric to the left. Hold the machine and gradually move the right hand to the right, while holding the cloth with the left hand to gently move the sewn object to the left according to the sewing rhythm until the sewing is completed; Cut the thread ends with scissors and gently pull up the pressure plate to remove the fabric. Pull out a piece of thread from the back of the sewn fabric, thread it into the next coil, tighten it and tie a knot, and the stitch will be secure; At the end of sewing, do not use hard pulling on the fabric to break the thread ends, in order to avoid damaging the needle and needle; 6. This function automatically feeds and adjusts the tightness between the pins, but the following points should be noted: if the pins are too tight, adjust the pressure nut slightly counterclockwise; The pin is too loose, adjust the pressure nut slightly clockwise; Tie the correct pins tightly. If you need a larger stitch, you can pull the cloth on your left hand slightly faster. If the stitches need to be tighter, the left hand can pull the cloth slightly slower; 7. Changing the coil: If using a large coil, the spare extension rod can be connected to the coil shaft and inserted into the large coil. Place the spare plastic cap at the end of the rod to fix the large ball of thread, then thread it again, adjust the tightness of the thread, and then sew it; Use cotton or synthetic thread effects. 8. Needle replacement: Loosen the fixing screw and remove the broken needle. Install the new needle as shown, taking care to align the flat surface of the needle with the fixing screw and not install it upside down. Pocket type, manually operated, this sewing machine has the function of automatically feeding fabric and adjusting the tightness between pins, achieving professional results;
Daha fazlasını gör
3.01$
5
9 yorumlar 25 satıldı
Mini Handheld Sewing Machine Household Portable Manual Handheld Pocket Outdoor Travel Small Sewing Machine